Cross T-shaped groove bending plate

The cross T-shaped groove bending plate is used to inspect the 90 ° angle of the workpiece, check the perpendicularity of the relevant surfaces of the parts during equipment maintenance, and is also commonly used for marking by fitters. And it can be commonly used for inspection, installation, and vertical surface inspection of machine tools, and can check the perpendicularity of workpieces on cast iron plates. It is suitable for mechanical and instrument inspection and inspection of non perpendicularity between machine tools.

Do not use and store the cross T-shaped groove bending plate in damp, corrosive, high and low temperature environments. When using, the bending plate should be installed and debugged, and then the working surface of the bending plate should be wiped clean. After confirming that there are no problems, the bending plate can be used. Purpose: Used for inspection, installation, and vertical surface inspection of machine tools, and can check the perpendicularity of workpieces on cast iron flat plates (cast iron platforms). Suitable for mechanical and instrument inspection and inspection of non perpendicularity between machine tools according to standards.

The cross T-shaped groove bending plate is used to inspect the 90 ° angle of the workpiece, check the perpendicularity of the relevant surfaces of the parts during equipment maintenance, and is also commonly used for marking by fitters. And it can be commonly used for inspection, installation, and vertical surface inspection of machine tools, and can check the perpendicularity of workpieces on cast iron plates. It is suitable for mechanical and instrument inspection and inspection of non perpendicularity between machine tools.

Precautions for cross T-shaped groove bending plate: Do not use and store the bending plate in damp, corrosive, high and low temperature environments. When using, the bending plate should be installed and debugged, and then the working surface of the bending plate should be wiped clean. After confirming that there are no problems, the bending plate can be used.