Application of Machine Tool Anti vibration Pad Iron in Mechanical Machine Tools

Application of machine tool shock-absorbing pad iron in mechanical machine tools:

Machine tool shock-absorbing pad iron is also a commonly used shock-absorbing device on machine tools. Its existence effectively protects the normal operation and work of the machine tool. It is an accessory that can be selected according to specific requirements during use. Based on its physical performance indicators, we have made the following reference indicators. These factors are the main considerations when choosing shock-absorbing pad iron, which are mainly reflected in the following aspects. We hope to provide you with assistance in improving. Lift the machine and place the shim in place. Insert the bolt into the shim through the machine installation hole and place the machine onto the shim. Turn the bolt clockwise to adjust the machine's degree. After leveling the machine protective cover, tighten it with a nut.

Machine tool shock-absorbing pad iron

One of the main characteristics of machine tool shock-absorbing pad iron is that it can have a shock-absorbing effect on the machine tool. The symbol of vibration reduction performance is the transmission rate. Reducing the natural frequency of the system can reduce the transmission rate and improve the vibration reduction effect. The parameter of amplitude control is damping, but it is ineffective in the actual damping area. Therefore, when selecting a shock absorber, it is worth paying attention to how to choose the damping coefficient. The evaluation of transmission rate is relative, and it should be judged based on the damping force of the machine equipment and the allowable degree of the equipment environment to determine the quality of the vibration isolation steel wire pipe system.

A simple method for selecting shock-absorbing pad iron for machine tools can be done by determining the support point and using frequency ratios. Usually, manuals and samples of various shock absorbers indicate three parameters: rated load, natural frequency, and damping coefficient. Designers can choose according to the actual situation of the vibration system. This is a small and fundamental form of parameter description. In fact, a vibration system consists of rotational motion around three axes of motion, with a total of six degrees of freedom. Vibration isolation design involves selecting support points. Consider the system as much as possible in terms of degrees of freedom.

The advantage of using machine tool shock-absorbing pad iron is that it can save device costs and shorten device cycles. Machine tool positions can be exchanged at any time based on consumption, eliminating the cost of secondary equipment and making it possible to install equipment on the machine tool floor. Machine tool shock-absorbing pad iron can adjust the degree of machine tool, with a wide range of adjustment and convenient operation. The shock-absorbing rubber pad is made of nitrile synthetic rubber, which is resistant to grease and coolant. Application method of machine tool shock-absorbing pad iron: Place the required pad iron under the foot hole of the machine tool, insert the bolt, rotate it until it is in solid contact with the load-bearing plate, and then stop adjusting the degree of the machine tool (rotate the bolt clockwise to raise the machine tool); After adjusting the degree of the machine tool, tighten the nut and fix it in place. Due to the creep phenomenon of rubber, the machine tool should be adjusted once every two weeks after the use of the shim.